|Contributions||U.S. Customs Service.|
|The Physical Object|
|Pagination|| p. ;|
|Number of Pages||11|
MARKING GUIDE. 1. MARKING GUIDE. GSA contracting laws require contracting officers to include the clause at , Marking, in solicitations and contracts for supplies when deliveries may be made to both civilian and military activities and the contract amount is expected to exceed the simplified acquisition Size: KB. UN Specification Marking Requirements Part , Subpart L Manufacturers test and mark packagings according to UN Standards Specified Codes used for marking Markings must be durable, legible and placed according to Subpart L - 23 -File Size: 2MB. ESD sensitive electronic device, requirements of MIL-STD apply. Markings shall be omitted for sensitive, controlled or pilferable items per MIL-STD MIL-STDB/2C Code: Marking shall be accomplished in accordance with the marking requirements in the . are specifically exempted from country-of-origin marking requirements, and with such other marking as is required by the marking laws of the United States. Exemptions and general marking requirements are detailed in Chapters 29 and 7. Comply with the provisions of any special .
For additional requirements relating to imported firearms, see Customs regulations at 19 CFR part Firearm frames or receivers. A firearm frame or receiver that is not a component part of a complete weapon at the time it is sold, shipped, or otherwise disposed of by you must be identified as required . Marking Classified National Security Information AS REQUIRED BY EXECUTIVE ORDER , CLASSIFIED NATIONAL SECURITY INFORMATION DECEM , AND I 32 CFR PART , ISOO IMPLEMENTING DIRECTIVE J DECEMBER Revision 4, January This document is UNCLASSIFIED. Any classification I markings are for training use only. ST/SG/AC/1/Rev () Recommendations on the TRANSPORT OF DANGEROUS GOODS Model Regulations Volume II Sixteenth revised edition UNITED NATIONS. Provides item marking criteria for development of specific marking requirements and methods for identification of items of military property produced, stocked, stored, and issued by or for the DoD, including criteria and data content for both free text and machine-readable information (MRI) .
of its safeguarding requirements. Markings shall be uniformly and conspicuously applied to leave no doubt about the classified status of the information and the SAP protection required. d. Marking challenges pertaining to SAP material shall be forwarded through the program security officer (PSO) to the CA Special Access Program Central Office. NRC Information Security Branch if you have questions on SGI marking requirements. SGI is a special category of sensitive, unclassified information required by Section of the AEA to be protected. Although SGI is sensitive, unclassified information, it is marked and protected in many aspects similar to Confidential National Security Information. The identification bar code marking shall be applied at least 2 inches ( mm) from the top and bottom edges and at least 1 inch ( mm) from the side edges of the box or crate. A quiet zone of at least inch ( mm) from the ends of the bar code to the nearest identification marking shall be maintained. Marking is the principal way of letting holders of information know the specific protection requirements for that information. Marking and designation of classified information are the specific responsibility of original and and derivative classifiers. eLearning Courses. Internet-based, self-paced training courses.